Module 108 - Single Voice
This module, the Voice 108 contains all of the essential elements of an analogue synth in a single 'voice' module. It uses toggle switches for patching with additional jack sockets for integrating into your modular synth.
Voice 108 Functions: VCO, LP VCF, VCA, ADSR, LFO, Noise generator, Mixer & Gate Pulse Generator
Voice 108 Patching:
- ADSR gate - internal from repeat gate generator or external source
- VCO frequency modulation from LFO or ADSR
- VCO PWM modulation from LFO or ADSR
- VCF cut-off modulation from LFO or ADSR
- VCF cross modulation from LFO or ADSR
- VCA level from LFO or ADSR
Features
VCO Features:
- 1 Volt / Octave CV
- Coarse and fine VCO frequency controls
- PWM control
- CV control of VCO pulse width modulation (PWM)
- Sub-octave square wave output 1 octave below main frequency
- Jacks for VCO Sine, Triangle, Saw and Pulse waveform outputs
VCF Features:
- 1 Volt / Octave CV
- CV control of VCF cut-off, cross modulation and resonance
- Controls for cut-off, resonance and cross modulation
VCA Features:
- CV control of VCA level
- Initial level control
LFO Features:
- LFO waveforms square, saw, triangle & ramp
- Level and rate controls
Gate Pulse Generator:
- Gate rate control
Mixer Features:
- Six mixer level controls for VCO pulse, sub-octave, saw, triangle, sine + noise
- Common voice output jack
ADSR Features:
- Controls for Attack, Decay and Release envelope phases along with the Sustain level
- Time range selection switch x1 / x10
- Gate input for full ADSR output
- Illuminated manual gate button
- LED indicator of gate pulse
- ADSR output level control
Specification
- Supply voltage +/-12Vdc (note: this module uses two power supply connectors for load sharing)
- Supply current J1: +68mA / -68mA, J2: +12/-26mA
- Panel width: 4U
- Waveform levels +/-5V
- VCO frequency range without applied CV 20Hz to 13.6kHz
- LFO frequency range 0.037Hz to 17Hz
- Gate frequency range 0.038Hz to 9Hz
Available to order, dispatched in 3-4 weeks
£444.00
Ex Tax: £370.00